Welcome to the official website of Shandong Giant Chung Machine Tool Co., Ltd.!
Preparations for the machining center when processing products
Release Time:
Jan 16,2024
When entering the workshop for probation, you should wear good work clothes, tie up your big sleeves and tie your shirt into your pants. Girls should wear safety helmets and include braids in their hats. Do not wear sandals, sandals, high-heeled shoes, camisole, long skirts and scarves into the workshop. Note: Gloves are not allowed to operate the machine.
When the machining center is processing products, the equipment should be checked when the workpiece is turned on. The following small editor will introduce it to you:
1. basic matters: when entering the workshop for internship, you should wear good work clothes, tie up your big sleeves and tie your shirt into your pants. Girls should wear safety helmets and include braids in their hats. Do not wear sandals, sandals, high-heeled shoes, camisole, long skirts and scarves into the workshop. Note: Gloves are not allowed to operate the machine. Take care not to move or destroy the warning signs installed on the machine. Be careful not to place obstacles around the machine tool, and the indoor space should be sufficient during work. If two or more people must cooperate with each other in a certain job, they should pay attention to the coordination between them. Air compression cleaning machining center, electrical control cabinet and NC module are not allowed. The apprenticeship should be carried out on specific machine tools and electronic computers. Without permission, other machine tools and equipment, special tools or electrical switches cannot be moved.
2. preparation in advance: before the operation of the machining center, it is necessary to understand the general characteristics, structure, transmission system principle and management program of the numerical control machine tool, and grasp the function of each operation button, display lamp and the operation procedure flow. It is not necessary to carry out the operation and adjustment of the machine tool before understanding the whole operation process. Before starting the machining center, check whether the automatic control system of the electrical equipment of the machine tool is normal, whether the air intake system is unobstructed, whether the oil is good, whether the operating rocker is properly filled with grease according to the regulations, whether the product workpiece, tooling fixture and numerical control blade are clamped firmly, whether the refrigerating fluid is abundant, then drive the machine at a high speed for 3-5 minutes, check whether all transmission system components are normal, and whether there is no problem, only then can everything be applied normally. After the debugging program is carried out, the instructor must be willing to operate according to the process, and it is not allowed to skip the process. Without the approval of the instructor, those who operate without permission or violate traffic regulations, and whose examination results are solved with zero points, resulting in safety accidents, shall be punished according to relevant requirements and compensate for the corresponding damages. Before the machining center produces and processes parts, it is necessary to strictly check whether the starting point of the machine tool and the data information of the numerical control blade are all normal and carry out the simulation operation of the non-drilling motion trajectory.
Keywords:
Recommended News
Do you have any questions about our products or after-sales service?
Contact us easily through the following methods:
WhatsApp：8615706325866
Phone:+86-15706325866
Email:Leo@giantchung.com
