Welcome to the official website of Shandong Giant Chung Machine Tool Co., Ltd.!
Spindle Repair Preparation of NC Machining Center
Release Time:
Jan 16,2024
If the spindle speed is not normal, that is, after the spindle is given the command speed, the reaction speed on the CNC machining center is inconsistent with the command speed (generally less than the command speed). It may be that the spindle of the CNC machining center is not smooth and abnormal.
If the spindle speed is not normal, that is, after the spindle is given the command speed, the reaction speed on the CNC machining center is inconsistent with the command speed (generally less than the command speed). It may be that the spindle of the CNC machining center is not smooth and abnormal. The sound is loud and slow, and in some cases, the motor may even have an overcurrent alarm. For the CNC machining center spindle, in the case of encoder response, the speed command "S" given by the CNC machining center machine is followed by a number, which will reflect the same value on the system flash.
The main drive of the CNC machining center spindle can be used with a belt drive or a gear drive. Most of them are now driven by synchronous belts in belt drives. The speed is not normal. It may be because the sync device is too long, so it has a sliding missing step. The coupling between the CNC machining center spindle and the spindle encoder is also used with the timing belt, and the same situation may be lost in this step. However, the smoothness of the CNC machining center spindle is not good, or any bearings on the spindle may burn out, resulting in excessive resistance of the CNC machining center and causing the spindle to fail.
Keywords:
Recommended News
Do you have any questions about our products or after-sales service?
Contact us easily through the following methods:
WhatsApp：8615706325866
Phone:+86-15706325866
Email:Leo@giantchung.com
